Five Things You Should Avoid When Using an Automatic Transmission

Driving a car with an automatic gearbox first appears to be simpler than driving one with a manual transmission. Automatic automobiles frequently feature a more user-friendly interface, and rookie drivers won’t have to fight with the clutch and seemingly erratic gear shift.

They should be able to focus more clearly on the road as a result. Despite the fact that operating an automatic gearbox can seem easy, there are a few ways you could accidentally harm your transmission.

I’ll outline five of the most hazardous errors you may make when using an automatic gearbox in this post.

Don’t let water get into the transmission

If water eventually gets into your transmission, you are in trouble. In fact, even the smallest amount of water can wreak havoc on your car’s transmission to the point of requiring its replacement.

When water infiltrates the transmission, it gets absorbed by the friction lining of the clutches. This causes the glue that connects the material and the clutch plates to dissolve.

However, if you’re lucky enough to notice the problem right away, you’ll save a lot of money because the damage won’t be so dramatic. eel, making it impossible to steer.

Don’t Shift to Neutral at Stoplights

Some people simply don’t feel like holding their foot on the brake pedal when at a red light, while others may have heard from experts that doing so might cause the gearbox to wear out.

Keeping your automobile in drive rather than shifting to neutral when stopped at a light is still preferable in any scenario. First off, you have less control over your automobile when it is in neutral, which may prevent you from performing an emergency move in time.

Additionally, you’d end up revving the engine and waste fuel if you forgot to put the car in neutral before the red lights turn green.

Don’t shift from drive to reverse before your car stops moving

We’ve all done this error at least once, especially when we’re rushing and unable to wait until we’ve stopped completely before switching from drive to reverse and vice versa.

You have the potential to seriously harm your transmission and its parts. When you make a shift while your automobile is still moving, the transmission serves as the vehicle’s brakes rather than the brakes itself.

If your brakes need to be replaced because of wear and tear, the cost will be high. Therefore, if you often switch between drive and reverse while the automobile is moving, be prepared for damage that might cost more than #100,000.

Never launch your car from a standstill

Launching generally involves revving the engine while the car is in neutral and then shifting into drive to accelerate quickly from a standstill.

The bands and clutches of the automatic gearbox suffer severe damage as a result. They employ friction to move certain parts while shifting, and if you rev in neutral and then switch to drive right away, these bands and clutches will wear out sooner.

Avoid putting your car in park before it stops completely

Now, if you have a recent vehicle, it most likely won’t allow you to commit this terrible error. This is due to speed sensors used in more modern auto models, which prevent this behaviour. However, if your vehicle lacks this kind of technology and you occasionally have the bad habit of shifting into park before the vehicle has stopped moving, keep in mind that you risk doing irreparable harm to your gearbox.

The park position is not intended to stop your automobile while it is still going; rather, it is meant to prevent your car from rolling away. Your car’s gearbox is locked up when it is in park.

As a result, the wheels either have no ability to move at all or may move only very slowly. A pin locks a gearbox output shaft that links to your car’s wheels when you move the gearshift into park, but if the engine is still running at the time, the locking pin may break or corrode.

Conclusion

Do any of these errors apply to you? What additional driving practices have you heard of that might harm an automatic transmission? Kindly get in touch with us in the comments section and let us know.